Table of Contents
Advertisement
MBT-5000 L-Band Up/Down Converter System
Upgrading Firmware
B. Using the MBT-5000 HTTP Interface 'Config | Utility' page: Click [Reboot Now] to soft
reboot the converter.
Upon reboot, the converter front panel "splash" screen should verify that the new
C.
firmware version is active, as shown in this example:
6) To load the second Firmware Image, use the converter front panel or the MBT-5000 HTTP
Interface 'Config | Utility' page to configure the target Image (1 or 2) as the Current Active
Firmware Image, and then repeat Steps 2 through 5.
The MBT-5000 is now operating with its latest firmware. The firmware update process is now
complete.
MBT-5000
Version: #.#.# SN #######
4–10
MN-MBT5000
Revision 4
Advertisement
Table of Contents
