Comtech EF Data MBT-5000 User's Installation And Operation Manual page 117

MBT-5000 L-Band Up/Down Converter System
Serial-based Remote Product Management
Command Arguments for
Parameter (Instruction Command or
Type Code and Response to
Qualifier)
Remote Baud SBR= 4 bytes
Rate
Serial Number N/A 9 bytes
Remote SPA= 4 bytes
Address
Set Statistics SSI= 2 bytes
Interval
Software N/A variable length
Revision
(Note that all arguments are ASCII numeric codes between 48 and 57)
Query
Command or Query.
Set remote baud rate as follows:
2400 = 2400 baud
4800 = 4800 baud
9600 = 9600 baud
19K2 = 19200 baud
38K4 = 38400 baud
Default Value: 9600
Example: <1/SBR=9600'cr'
>0001/SBR=9600'cr''lf'
Note: When changing baud rates remotely the response to the command will be returned using
the same baud rate as that used to send the command.
Query only.
Queries the unit 9-digit serial number. Unit returns its S/N in the form xxxxxxxxx.
Example: SNO=176500143
Command or Query.
Sets Physical Address - between 0001 to 9997. Resolution = 0001.
Example: <1/SPA=0412'cr'
>0001/SPA='cr''lf'
Default Value: 0001
Note: 9998 and 9999 are reserved for the block converter A and B if the base address is 9997.
Command or Query.
Sets i nterval at w hich statistics ar e l ogged. M inimum resolution i s 10 m inutes, m aximum i s 90
minutes in 10 minute intervals.
Default Value: 90
Example: <1/SSI=90'cr'
>0001/SSI='cr''lf'
Query only.
Unit returns the value of the internal software revision installed in the unit, in the form :
Boot:x.y.z Bulk1:x.y.z Bulk2:x.y.z
-or-
Boot:x.y.zz Bulk1:x.y.zz Bulk2:x.y.zz
Description of Arguments
7–17
MN-MBT5000
Revision 4
Response to Query
Response to query
Command (Instruction
(Target to Code and
Controller) Qualifier)
SBR= SBR? SBR=xxxx
SBR?
(See format as
Command
arguments)
N/A SNO? SNO=xxxxxxxxx
(See Description of
Arguments)
SPA= SPA? SPA=xxxx
SPA?
(Same format as
Command
arguments)
SSI= SSI? SSI=xx
SSI?
(Same format as
Command
arguments)
N/A SWR? SWR=Boot:x.y.zz
Bulk1:x.y.zz
Bulk2:x.y.zz
(See Description
of Arguments)
(Target to
Controller)