Run The Ks833A1A Event-Based Power Analysis Software - Keysight Technologies X8712A User Manual

Run the KS833A1A Event-Based Power Analysis Software

At this point, you will need to verify the module settings in the software to be the
same as your hardware connection before you turn on your N6705C unit.
1 Turn on your device-under-test (DUT) and place it in the shield box. Close the
2 Click Connect to verify your hardware connections.
3 Click Acquire to begin capturing the waveforms. The Acquire button will
During the measurement, the 'Acquire' button will change to 'Abort' button and
NOTE
disable the settings control listed on
click 'Edit' to enable settings control.
An example of a successful results as shown below. Capabilities of the software is
covered in
34
shield box.
change to 'Abort' during the measurement.
Chapter 2, "Result
page 30. Upon successful data acquisition,
Analysis".
Keysight X8712A User's Guide