Table of Contents
Advertisement
Pair an External Companion Device in Signaling Mode
The image below illustrates the typical setup to pair an external companion device
in signaling mode.
Follow the instructions below to connect the X8712A solution as shown above.
1 Follow the instructions from
2 Connect your companion device to the other front end connector of the
For sensitivity measurement, take note that the pass through loss between port
NOTE
1 and 2 of the X8712AD is approximately 7 to 8dB.
You have completed the hardware setup based on this example.
Go to
X8712A IoT Device Battery Life Optimization Solution.
Keysight X8712A User's Guide
DUT in Self Advertising or Test Mode
X8712AD RF Event Detector.
Software Installation
step 1
to
step 7
section.
section to install the required software to operate the
Getting Started
in the
Connect an Over-the-Air
1
21
Advertisement
Table of Contents
