Table of Contents
Advertisement
Channel
Channel 3 and 4
Voltage meter
Current meter
DC Power Supply
Take note of the following:
NOTE
– Channel 1 should be set as Battery Emulator
– Channel 2 should be set as RF Power Detector.
– Refer to software settings at
Based on the above mentioned hardware, the following section illustrates
examples of hardware setup depending on your choice of DUT and test
requirement.
– Two-channel Configuration on
– Four-channel Configuration (Channel 1 to 4) on
18
V
A
– Option 1: Connect an over-the-air DUT with self advertising or in test mode
– Option 2: Pair an external companion device in signaling mode
– Comparison of power levels between Option 1 and 2
– Use Contact or Non-Contact sensors with voltage or current behavior
response to synchronize the events
Settings
You can choose two options from below:
– Voltage meter
– Current meter
– DC Power Supply
Function: Measure voltage
Function: Measure current
Function: Force Voltage to measure Current
page
30.
page 19
page 23
Keysight X8712A User's Guide
Advertisement
Table of Contents
