Keysight Technologies X8712A User Manual page 20

5 There are two RF ports on X8712AD. Connect the RF cable (not included) to
– The 2 in 1 power combiner within the X8712AD produces equal RF signal on
NOTE
– You are recommended to connect the 50 Ohm terminator to the unused port
– The pass through loss between port 1 and 2 is approximately 7 to 8dB.
6 Connect the X8712AD RF Event Detector to Port 2, use V+ and V- 2-wire
7 The X8712AD RF Event Detector has a micro male adapter at the front panel
Set Channel 2 in Voltage meter (VMM) mode before you turn on the output,
CAUTION
to prevent generating DC output to the X8712AD RF Event Detector.
You have completed the hardware setup based on this example.
Go to
X8712A IoT Device Battery Life Optimization Solution.
20
one of the RF ports and the other end to the back of the shield box. Connect
the 50 Ohm terminator to the port not in use.
Port 1 and Port 2 on the front panel.
to avoid open reflection when you use one of the ports to measure RF power.
configuration to receive analog response at rear banana port as shown below.
The output will range from 0 to 2V.
as well, that requires 5V of DC to operate the event detector.
USB A to Micro cable,
5V DC
RF Input
Frequency range: 10MHz - 3GHz
Sensitivity: -40 to 0 dBm
Software Installation
V+
V-
Port 1
Port 2
section to install the required software to operate the
S+ S- adapter
for support only
Keysight X8712A User's Guide