Contents; Safety Information; Warning! Important Safety Instructions - EBARA TH Series Operating Instructions, Installation & Maintenance Manual

Operating, Installation, and Maintenance

Contents

Section
Introduction and Safety Information
TH Selection Chart
TH Specifications
TH Sectional View
Installation Instructions
Start-up Instructions
Operation
Maintenance and Service
TH Assembly
Troubleshooting Checklist
Introduction
This Operation, Installation, and Maintenance manual is designed to help you get the best
performance and longest life from your EBARA pump.
This pump is a TH Series, end suction centrifugal pump. It is capable of being used in a variety of
applications including heating, air conditions, pressure boosting, cooling water transfer and non-potable
water supply.
If you have any questions regarding the pump or its applications which are not covered in this manual or
in other literature accompanying this unit, please contact your local EBARA distributor or visit
www.pumpsebara.com.

Safety Information

Rules for Safe Installation and Operation
Read these rules and instructions carefully. Failure to follow them could cause serious bodily injury and/or property damage.
1.
Check your local codes before installing. You must comply with their rules and regulations
2.
For maximum safety, this product should be connected to a grounded circuit equipped with a ground fault interrupter
3.
device.
Before installing this product, have the electrical circuit checked by an electrician to make sure it is properly grounded.
4.
Before installing or servicing your pump, BE CERTAIN pump power source is disconnected.
5.
Make sure the line voltage and frequency of the electrical current supply agrees with the motor wiring. If motor
6.
is dual voltage type, BE SURE it is wired correctly for your power supply.
Complete pump and piping system MUST be protected against below freezing temperature. Failure to do so
7.
could cause severe damage and voids the Warranty.
Avoid system pressures that may exceed one and a half times the operating point selected from the pump performance
8.
curve.
Do not run your pump dry. If it is, there will be damage to the pump seal.
9.
Rev 10/2018
!
WARNING
IMPORTANT SAFETY INSTRUCTIONS
Page
2
4
7
8
9
12
12
12
14
20
2