EBARA TH Series Operating Instructions, Installation & Maintenance Manual page 17

Operating, Installation, and Maintenance
TH Assembly Instruction (Continued)
Pump Assembly – TH Frame Mounted
Step 1
Heat the bearings (item 849) to perform the assembly on the shaft
(item 031).
Note: If possible, we recommend using an induction heater to facilitate
assembly of bearings.
Step 2
Place the gaskets (item 117) in the bearing cover (item 845).
*Do not use any adhesive type to place the gasket (item 117).
Step 3
Install the shaft (item 031) with the bearings (item 849) into the
bearing housing (item 051) according the illustration.
Use soft face hammer to assemble.
Step 4
Attach the bearing covers (item 845) and fasten the hex head bolts
(item 120‐3).
Step 5
Fix O‐ring (item 115) at case cover (item 011). Use grease to hold the
O‐ring in place. Do not use any kind of adhesive, this should cause
chemical damage at rubber/elastomer.
Rev 10/2018
Gasket
17