Operating, Installation, and Maintenance
TH Assembly Instruction (Continued)
Pump Assembly – TH Frame Mounted
Step 6
Insert the stationary part of mechanical seal (item 696) into case
cover (item 011) using grease or another type of lubricant. Use a soft
face tool to avoid damages. After the stationary part is in place, clean
the face with an alcohol wipe.
Step 7
Use hex head bolts (item 120‐1) to fix the case cover (item 011) to
bearing housing (item 051).
Step 8
Place the rotating part of the mechanical seal on the shaft sleeve
(item 042), centring the washer to the impeller side.
Step 9
Lubricate the rotating part with grease to facilitate assembly.
Step 10
Place the shaft sleeve (item 042) and O‐ring (item 115‐2) on the shaft
(item 031).
Rev 10/2018
18