Registration Settings Configuration - Yealink W60P Administrator's Manual

Administrator's Guide for W60P/W53P/W41P DECT Phones
Example:
account.1.reg_fail_retry_interval = 30
Note: It works only if "account.X.reg_failed_retry_min_time" and "account.X.reg_failed_retry_max_
time" are set to 0.
Permitted Val-
Integer from 0 to 1800
ues
Default 30
Web UI Account->Advanced->SIP Registration Retry Timer (0~1800s)
account.X.reg_failed_retry_min_time
Parameter
It configures the base time to wait (in seconds) for the IP phone to retry to re-register account X
when registration fails.
Note: It is used in conjunction with the parameter "account.X.reg_failed_retry_max_time" to determ-
Description
ine how long to wait. The algorithm is defined in RFC 5626. We recommend you to set this value to
an integer between 10 to 120, if needed. If the values of this parameter and the parameter "accoun-
t.X.reg_failed_retry_max_time" are set to 0, the interval configured by "account.X.reg_fail_retry_inter-
val" will be used.
Permitted Val-
Integer greater than or equal to 0
ues
Default 0
account.X.reg_failed_retry_max_time
Parameter
It configures the maximum time to wait (in seconds) for the IP phone to retry to re-register the
account X when registration fails.
Note: It is used in conjunction with the parameter "account.X.reg_failed_retry_min_time" to determ-
Description
ine how long to wait. The algorithm is defined in RFC 5626. We recommend you to set this value to
an integer between 60 to 1800, if needed. If the values of this parameter and the parameter "accoun-
t.X.reg_failed_retry_min_time" are set to 0, the interval configured by "account.X.reg_fail_retry_inter-
val" will be used.
Permitted Val-
Integer greater than or equal to 0
ues
Default 60
[1]
X is the account ID. X=1-8.
[2]
Y is the server ID. Y=1-2.

Registration Settings Configuration

The following table lists the parameters you can use to change the registration settings.
account.X.enable_user_equal_phone
Parameter
Description It enables or disables the IP phone to add "user=phone" to the SIP header of the INVITE message.
Permitted Val-
0-Disabled
1-Enabled
ues
Default 0
98
[1]
<MAC>.cfg
[1]
<MAC>.cfg
[1]
<MAC>.cfg