Audio Features; Alert Tone; Alert Tone Configuration - Yealink W60P Administrator's Manual

Audio Features

This chapter describes the audio sound quality features and options you can configure for the IP phone.
Topics

Alert Tone

Ring Tones
Ringer Device
Tones
Audio Codecs
Packetization Time (PTime)
Early Media
Acoustic Clarity Technology
DTMF
Voice Quality Monitoring (VQM)
Advisory Tones
Alert Tone
You can configure the following audio alert for the phone:
Voice mail tone: allow the IP phone to play a warning tone when receiving a new voice mail. You can customize the
l
warning tone or select specialized tone sets (vary from country to country) for your IP phone.
Dial tone: allow the IP phone to play a specific dial tone for a specified time.
l
Topic

Alert Tone Configuration

Alert Tone Configuration
The following table lists the parameters you can use to configure the alert tone.
Parameter features.call.dialtone_time_out
It configures the duration time (in seconds) that a dial tone plays before a call is dropped.
Example:
features.call.dialtone_time_out = 30
Description
The IP phone will stop playing the dial tone after 30 seconds when on the dialing screen and then
return back to the idle screen.
If it is set to 0, the call is not dropped.
Permitted Val-
0 to 65535
ues
Default 15
Parameter features.voice_mail_tone_enable
It enables or disables the IP phone to play a warning tone when it receives a new voice mail.
Description
Note: It works only if "account.X.display_mwi.enable" is set to 1 (Enabled).
Permitted Val- 0-Disabled
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Audio Features
165