Multicast Paging Settings Configuration - Yealink W60P Administrator's Manual

Administrator's Guide for W60P/W53P/W41P DECT Phones
Topic

Multicast Paging Settings Configuration

Multicast Paging Settings Configuration
The following table lists the parameters you can use to change multicast paging settings.
Parameter multicast.codec
It configures the codec for multicast paging.
Description Example:
multicast.codec = G722
Permitted
PCMU, PCMA, G729, G722
Values
Default G722
Web UI Features->General Information->Multicast Codec
Parameter multicast.receive_priority.enable
It enables or disables the IP phone to handle the incoming multicast paging calls when there is an active
Description
multicast paging call on the IP phone.
0-Disabled, the IP phone will ignore the incoming multicast paging calls when there is an active multicast
paging call on the IP phone.
Permitted
Values
1-Enabled, the IP phone will receive the incoming multicast paging call with a higher priority and ignore
the one with a lower priority.
Default 1
Web UI Directory->Multicast IP->Paging Priority Active
Parameter multicast.receive_priority.priority
It configures the priority of the voice call (a normal phone call rather than a multicast paging call) in pro-
gress.
Description
1 is the highest priority, 31 is the lowest priority.
0-Disabled, all incoming multicast paging calls will be automatically ignored when a voice call is in pro-
gress.
1-1
2-2
Permitted
3-3
Values
...
31-31
If it is set to other values, the IP phone will receive the incoming multicast paging call with a higher or
equal priority and ignore the one with a lower priority when a voice call is in progress.
Default 31
Web UI Directory->Multicast IP->Paging Barge
Parameter multicast.listen_address.X.volume
162
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
[1]
<y0000000000xx>.cfg