Table of Contents
Advertisement
User Manual
a. Procedure (to Attach)
1
Pressure Port
Figure 2-2 Attach / Remove Pressure connections
Step
1
2
3
Page 39 of 105
2
a. NPT
b. (G)/BSPP
P≥100 bar
c. (G)/BSPP
P≤100 bar
Table 2-1
Remove the adaptor
Use an applicable seal for the pressure connection:
a. NPT type: Use an applicable sealant on the thread.
b. BSP (parallel) type: We recommend a bonded seal at
the bottom.
c. BSP (parallel type, 100 bar (1500 psi) or less: a bonded
seal at the top is permitted.
Attach the adaptor to the device; if necessary use one of
the alternative adaptors listed in Section 1.10
(Accessories), then tighten to the applicable torque.
Procedure
[EN] English – 109M4017 Revision -
Druck DPI612
3
Advertisement
Table of Contents
