Install Dry Cell Batteries - GE Druck DPI612 User Manual

User Manual
1.9.3

Install Dry Cell Batteries

1. Remove the battery cover by loosening the captive battery cover
fixing screw and lifting the cover upwards.
2. If the rechargeable battery has been fitted, remove it.
3. If the rechargeable battery cradle has been fitted, remove it by
gently pulling it straight up. Avoid touching the metal contacts on
the cradle. Note the cradle is attached to the unit with the
charging cable.
4. Disconnect the charging cable from the back of the cradle and
keep it loose in the small compartment then fit battery holder.
5. Fit the foam block to the battery cover.
6. Place the batteries in the battery compartment with the correct
+/– position.
Incorrect Insertion of batteries can cause battery failure.
7. Replace the battery cover by pressing the lugs inside
the slots (A) and bring down the cover, securing by tightening the
fixing screw. (See Figure 1-2).
Page 17 of 105
[EN] English – 109M4017 Revision -
Druck DPI612