User Manual
1.5
ELECTRICAL WARNINGS
The DC input to the DPI611 is rated at 5V (+/-5%) 4 Amps.
•
External circuits should have appropriate insulation to the
•
mains.
To prevent electrical shocks or damage to the instrument, do
•
not connect more than 30V CAT I between the terminals or
between the terminals and the ground (earth).
This instrument uses standard AA size batteries. To prevent an
•
explosion or fire do not short circuit.
The power supply input range to the optional power supply
•
unit is 100 – 260Vac, 50 to 60Hz, 250mA, installation category
CAT II.
When using the optional power supply unit as position the
•
power supply so as not to obstruct the supply disconnecting
device.
Note that the operating and storage temperature range of
•
the optional PSU does not match that of the DPI611. Mains
PSU operating temperature range 0°C to +40°C, storage
temperature range -40°C to +70°C.
To make sure the display shows the correct data, disconnect
•
the test leads before power is set to ON or changing to
another measure or source function.
Keep the leads free from all contaminants.
•
Page 9 of 79
[EN] English – K0571 Issue 1
Druck DPI611