Preparation For Installation - NTI ST-C5KVMA-600 Installation And Operation Manual

600 foot extenders, ps/2 kvm extender, xtendex series
Hide thumbs Also See for ST-C5KVMA-600:
Table of Contents

Advertisement

NTI XTENDEX 600 Foot Extenders

PREPARATION FOR INSTALLATION

Locations should be chosen for the monitors, mice, and keyboards that also have space to connect the Remote and Local
Units within the distance provided by the cables.
The CATX cables must be run to the locations where the Remote and Local Units will be connected. Be careful to route the
cables away from any sources of magnetic fields or electrical interference that might reduce the quality of the video signal
(i.e. AC motors, welding equipment, etc.).
All cables should be installed in such a way that they do not cause stress on their connections to the equipment. Extended
lengths of cable hanging from a connection may interfere with the quality of that connection.
minimize this.
Properly shut down and disconnect the power from the CPU and monitors to be separated.
whose connections are being interrupted, be sure to refer to the instruction manuals for that equipment for proper
disconnection and re-connection procedures before proceeding.
Local and Remote Units should be grounded through either a display or source that uses a 3-prong power cord. If only one
unit is grounded, shielded CAT5 cable should be used.
Note: CATX connection cable used between NTI XTENDEX Series Local and Remote or any XTENDEX Series products
should not be run underground, outdoors or between buildings.
WARNING: Outdoor or underground runs of CATX cable could be dangerous and will void the warranty.
External Ground
This product is equipped with grounding hardware to prevent interference
from sources of electrical noise that could interfere with the normal operation
of the XTENDEX or damage it. Use either the crimp-on lug or solder terminal
to secure a properly grounded wire (connected to earth ground) to the
XTENDEX.
Failure to make this connection may result in poor video quality at the
connected monitor(s).
If extension cables are needed, contact NTI for the cables required.
7
Secure cables as needed to
If other equipment is involved
Crimp-on
Solder
terminal

Advertisement

Table of Contents
loading

Table of Contents