NTI ST-C51394-250 User Manual

Firewire cat.5 extender

Advertisement

FireWire Cat.5 Extender
USER'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ST-C51394-250 and is the answer not in the manual?

Questions and answers

Summary of Contents for NTI ST-C51394-250

  • Page 1 FireWire Cat.5 Extender USER’S MANUAL...
  • Page 2: Package Contents

    INTRODUCTION Congratulations on your purchase of the FireWire Cat.5 Extender. This FireWire Cat.5 Extender is capable of sending IEEE1394 signals across a Cat.5e/6 cable up to 75meters at data rate of 400Mbps & 120meters at data rata of 100Mbps. This Extender is optimized to create long-haul IEEE1394b-2002 connections over Cat.5e or Cat.6 at the S400 rate, but it can also be used at S200 and S100.
  • Page 3 FEATURES: Fully supports provisions of IEEE 1394a.2000 and 1394.1995 Standard for High Performance Serial Bus. Fully interoperable with FireWire, SB1394, DishWire, and i.LINK. Implementation of IEEE Std. 1394 Fully Supports Provisions of IEEE Std 1394b-2002 at S400B Signaling Rates Equipped with a multi-rate adaptive equalizer which restore IEEE Std 1394 signals received over Cat.5 or Cat.6 Unshielded Twisted Pair (UTP) Cable at 400 Megabits per Second ( Mbits/s ) Typical Equalization Performance...
  • Page 4 INSTALLATION: There are two FireWire Cat.5 Extenders included in the package. Both units can act as either transceiver or receiver. 1. Connect the FireWire Cat.5 Extender to the host system with an IEEE1394 cable (with IEEE1394b Bilingual/Beta 9 Pin Connector ). 2.
  • Page 5: Specifications

    SPECIFICATIONS One IEEE1394b Bilingual 9 Pin Connector One RJ-45 Port Works with PC, Macs and Linux Full Duplex Data Rate at up to 400Mbps Compatible with 1394a and 1394b Standard Bus powered or self powered Low Power consumption:2.7W(DC9V/0.3A) Standard CAT.5e/6 Cable Operating Temperature(-45℃...
  • Page 6: Weee Information

    Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received. Including interference that may cause undesired operation.

Table of Contents