Viscount Cantorum Dou User Manual page 72

User Manual
-
PIPE: the [MIDI OUT] port transmits MIDI data after actions applied to the organ and also the
data received through the [MIDI IN] port. If a Cantorum Duo combination is recalled by a MIDI
Program Change message received from an external device (for more information read par. 10.6)
such as a MIDI sequencer, Cantorum Duo will transmit the content of the combination (stops,
couplers, tremulant) to the [MIDI OUT] port.
Always use this mode when Cantorum Duo is connected to a digital pipe interface VPI
(Viscount Pipe Interface), to ensure a complete compatibility between the two devices.
SELECTING THE INPUT AND OUTPUT CHANNELS (MIDI CHANNELS function)
The organ can send out and receive MIDI messages on a single channel for each section. To set the MIDI
channels, select the CHANNELS field in the MIDI menu. The following page will appear:
The column on the left lists the organ sections; for each section a channel from the TX (transmission
channel) and RX (receiving channel) can be assigned. Press [EXIT] to leave the screen and save the
settings. OFF mode disables the transmission and/or reception of all MIDI messages for the selected
organ section.
To quit the page and save the current settings, press [EXIT].
FILTERS SETTINGS (MIDI FILTERS function)
A MIDI filter allows to block a particular message on all MIDI channels (if the signal is channelled). The
Control Change filter, for example, blocks these MIDI messages in the [MIDI OUT] port, on all MIDI
channels of the organ. In the same way, the receiving filter blocks PC on all channels (therefore they are
not executed when recalling combinations, Tutti, Crescendo) received from the [MIDI IN] port.
To configure the MIDI filters, select the FILTERS field in the MIDI menu.
Cantorum Duo
MIDI
player
MIDI OUT
[MIDI IN]
MIDI OUT
MIDI
MIDI MIDI
IN 1 IN 2
merger
Sound
generator
[MIDI OUT]
EN - 16
VPI
MIDI OUT