Viscount Cantorum Dou User Manual page 62

User Manual
11. General combinations.
-
[1] / [6]: pistons to recall the combinations saved in the selected memory bank (see [PREV] /
[NEXT] point). These combinations can be modified. To do so, follow the procedure described at
point 9.
-
[HR]: restores the voice setup prepared in manual mode before a memory was recalled.
-
[PREV.] / [NEXT]: general combinations sequencers. [PREV.] displays them in descending order,
[NEXT] in ascending order. Keeping pressed the [S] thumb piston and acting these commands it
is also possible to select the memory bank.
12. General organ controls: these are the controls that are not dedicated to a single section, but affect
the whole instrument.
-
[A.P]: enables the Automatic Pedal which allows the pedal voices to be played on the first manual.
In this case, the organ's pedal board is deactivated and the voices become monophonic, with
priority to the lowest note.
-
[ENC]: when the Enclosed function is active, the main volume can be controlled through the
expression pedal connected to the [EXPR.] connector ot the rear panel.
-
[C]: Cancel piston. Turns off all stops, tremulants, couplers and all other pistons on the manuals,
then deletes and turns on the HR. In case you have chosen to save into combinations the status of
[ENC] nad [A.P] pistons (see COMBINATIONS function in the par. 5.6), these are not turned off
by Cancel.
13. [T] piston: piston that recalls Tutti. The Tutti can be modified, for further information read point 9.
14. Couplers thumb pistons: here are the thumb pistons for the activation / deactivation of the couplers
between the manuals and the pedalboard:
-
[I/P]: coupler of the first manual with the pedal board
-
[II/P]: coupler of the second manual with the pedal board.
-
[II/I]: coupler of the second manual to the first.
15
15. [OUT 1] and [OUT 2] audio outputs: Jack line outputs with the organ stereo signal, based on the
settings of the video page described in par. 5.3. These outputs also has dedicated level and equalization
controls (see par. 4 and 5.2). In case of stereo system, connect the [L/MONO] output to the left
channel and the [RIGHT] output to the right channel. If a monophonic system is used, only connect
the[L/ MONO] connector.
16. [PEDALS] connectors: in these connectors it is possibile to connect pedals to control the following
functions:
-
[SUSTAIN]: connector for a switch-type pedal to control the Sustain effect for orchestral voices.
-
[EXPR.]: continuous control of Man.II volume.
-
[CRESC.]: With this pedal you can select the Crescendo level. These levels activate a fixed set of
stops, linked with an equal number of loudness, from pianissimo to fortissimo.
17 18
16 18
EN - 6
20 21 22