Danfoss VLT AutomationDrive FC 361 Operating Manual page 34

Electrical Installation
Terminal
18 Parameter 5-10
Digital Input
19 Parameter 5-11
Digital Input
32 Parameter 5-14
5 5
Digital Input
33 Parameter 5-15
Digital Input
27 Parameter 5-12
Digital Input
29 Parameter 5-13
Digital Input
20
Table 5.2 Digital Input/Output Terminal Descriptions
Terminal
39
42 Parameter 6-50
50
53
Analog Input 1
54
Analog Input 2
55
Table 5.3 Analog Input/Output Terminal Descriptions
32
Digital input/output terminals
Parameter Default
setting
[8] Start Digital inputs.
Terminal 18
[10]
Terminal 19 Reversing
[0] No
Terminal 32 operation
[0] No
Terminal 33 operation
[2] Coast For digital input or
Terminal 27 inverse output. Default
setting is input.
[14] JOG
Terminal 29
– – Common for digital
inputs and 0 V
potential for 24 V
supply.
Analog input/output terminals
Parameter Default
setting
– – Common for analog
output.
[0] No Programmable analog
Terminal 42 operation output. 0–20 mA or
Output 4–20 mA at a
maximum of 500 Ω.
– +10 V DC 10 V DC analog
supply voltage for
potentiometer or
thermistor. 15 mA
maximum.
Parameter Reference Analog input. For
group 6-1* voltage or current.
Switches A53 and
A54 select mA or V.
Parameter Feedback
group 6-2*
– – Common for analog
input.
Danfoss A/S © 06/2018 All rights reserved.
VLT® AutomationDrive FC 361
Relay terminals:
Description
RELAY 1
01 02 03
Illustration 5.12 Relay 1 and Relay 2 Terminals
•
•
Description
RELAY 2
04 05 06
Relay 1 and relay 2. The location of the outputs
depends on the drive configuration. See
chapter 3.5 View of Control Shelf.
Terminals on built-in optional equipment. See the
manual provided with the equipment option.
MG06I102