Advertisement
6. PROGRAMMING (continued):
ANTI-COLLISION SENSITIVITY
The unit has an Anti-Collision Sensitivity that will stop its movement if it hits something on the way down
or up. You can change this Sensitivity level by doing the following:
l. Press the DOWN button until the unit reaches the lowest position. Release button.
2. Press the DOWN button until display flashes "RST".
3. Press the UP button until display shows "10.5", "10.6", or "10.7" and goes back to "RST".
"10.5" is code for the 10 kg (22 lbs) setting (most sensitive setting, false positives are
sometimes possible).
"10.6" is code for the 15 kg (33 lbs) setting
"10.7" is code for the 20 kg (44 lbs) setting (least sensitive setting).
Note: While "RST" is still flashing, you can press the UP button as many times as you'd like
to toggle between the three settings.
4. Press the DOWN button until the unit lowers slightly, then rises slightly and the display
changes back to the numeric height setting.
7. TROUBLESHOOTING
If the unit does not respond when trying to raise or lower it, or if the Keypad displays error messages ("Er1"
through "Er13") check to make sure all the cables are secure (Lifting column to cable, cables to control
box). If the problem persists, perform the reset procedure below.
- Reset Instructions -
1- Unplug the power cord and hold the DOWN button for 30 seconds.
2- Plug the power cord back in.
3- Press and hold the DOWN button on the Keypad until the unit reaches its lowest height.
Release the DOWN button. Press and hold the DOWN button again until
the LED display reads "RST" (about 10 seconds). Release the DOWN
button. Press and hold the DOWN button again until the unit lowers a
little bit more, slightly rises and stops. Release the DOWN button.
It is now ready to use.
4- The Keypad will then display the current height, and you should be able to operate it now.
5- You may need to do this if the unit is ever unplugged or loses power.
If the error messages persist after the reset procedure, stop the reset procedure and contact The Human
Solution (800.531.3746 or info@thehumansolution.com).
If the Keypad displays "HO1", then it is hot. Let the base cool down for 20 minutes.
CAUTIONS & WARNINGS
!
CAUTION: Read all instructions before assembly. Failure to assemble properly may result in
!
damage or personal injury.
WARNING: Keep hands clear of the column while it is rising and falling. Do not touch it.
!
CAUTION: The maximum load capacity of the unit is 110 lbs. Do not overload.
!
CAUTION: Keep devices centered and away from the edge of the main worksurface,
!
to prevent them from falling.
CAUTION: Make sure that the wires for your monitor and devices have enough slack to prevent
!
your devices from being pulled off the unit workstation when raising the unit.
CAUTION: When relocating the unit, remove all devices to avoid harm or damage,
!
and adjust the unit to its lowest position.
CAUTION: When relocating the unit, move it carefully with two people, to avoid injury and
!
damage to the product and surroundings.
Copyright Notice: These instructions are a component of the UPLIFT Desk E7 Electric Standing Desk Converter. These instructions are part of the scope of delivery, even if the item is resold. These instructions
©
are also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk.
These instructions are subject to United States copyright law.
UPLIFT Desk • 1-800-349-3839 • info@upliftdesk.com • www.upliftdesk.com
*Note: "RST" will look like
"ASr" on the display
Advertisement
