Advertisement
Troubleshooting
For more troubleshooting information, visit the Desk Reset + Troubleshooting Steps at the URL below.
https://www.upliftdesk.com/uplift-desk-troubleshooting-and-reset-instructions/
f the error message persists after performing the Reset Procedure or if there is a height dif-
I
ference between the legs which exceeds 1.5'', refer to the Desk Reset + Troubleshooting Steps
page at the URL shown below.
https://www.upliftdesk.com/uplift-desk-troubleshooting-and-reset-instructions/
CODE
H01
E01-E06
E07-E012
!
CAUTIONS & WARNINGS
CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may
!
result in damage or personal injury. Retain manual for future reference.
© UPLIFT Desk • 800-349-3839 • info@upliftdesk.com • upliftdesk.com
90.014.01.0469 v.C
DESCRIPTION
The desk motor has a 10% duty cycle to protect it from
overheating. For example, in a 20 minute period, if your desk
Overheated
motor is activated for 2 minutes, you will want to let it rest
for 18 minutes. Otherwise you may see an H01 code on your
keypad.
Firmware
Check all cables to ensure they're all firmly plugged in, and
or connectivity
perform the Reset procedure on Page 1, Step 3.
issues
Legs are uneven
Perform Reset procedure on Page 1, Step 3.
If your desk does not respond when you try to raise
it or lower it or if the Keypad displays error messages
("E01" through "E12"), check to make sure all the ca-
bles are secure (cables to the legs and cables to the
control box).
If the problem persists, follow the steps below.
• Unplug the power cord and press down on the
Paddle for 30 seconds.
• Plug the power cord back in.
• Perform the Reset Procedure outlined on Page 2
Step 6 of these installation instructions.
Note: If the desk is unplugged or if you lose power,
you may need to perform the Reset Procedure.
TROUBLESHOOTING SOLUTION
AI-FRM055-2.2
Advertisement
