Troubleshooting; Technical Specifications - Uplift Desk FRM300 Instructions Manual

3-leg height adjustable standing desk

Hide thumbs

page of 16

/ 16
Troubleshooting
Bookmarks

If your desk does not respond when trying to raise or lower it, or if the Keypad displays error messages ("Er1"

through "Er13") check to make sure all the cables are secure (legs to cables, cables to control box). If the

problem persists, perform the reset procedure below.

RESET INSTRUCTIONS

Unplug the power cord and hold the DOWN button for 30 seconds.

2. Plug the power cord back in.

3. Hold the DOWN button on the Keypad until the desk reaches its lowest height, then release.

Hold the DOWN button again until the LED display reads "RST"

(or for about 10 seconds on non-LED keypads), then release.

Hold the DOWN button again until the desk lowers bit more, then

slightly rises and stops, then release. Your desk is now ready to use.

4. The Keypad will then display the current height, and you should be able to operate the desk.

5. You may need to do this if the desktop is ever unplugged or loses power.

If the error messages persist after the reset procedure, or if there is a height difference between the legs

which exceeds 1.5'', stop the reset procedure and contact UPLIFT Desk at the email address or phone num-

bers listed at the bottom of each page of these instructions.

If the Keypad displays "HO1", then it is hot. Let the base cool down for 20 minutes.

If the desk seems to be uneven, try the reset instructions above. If that does not work you may need to adjust

the leveling studs at the bottom of the foot.

Height Range

Travel Speed

Max Lifting Capacity

Duty Cycle

Input

Output

Copyright Notice: This guide is a component of the UPLIFT Desk™. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: upliftdesk.com.

Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.