Troubleshooting; Starting And Stopping - Uplift Desk UPL961 Quick Start Manual

Height adjustable conference table and conference ping-pong table

Hide thumbs Also See for UPL961:

Manual (17 pages)

Table Of Contents

Table of Contents

If your desk does not respond when you try to raise it or lower it, or if the Keypad displays error messages from "E01"

through "E012", check to make sure that all the cables to the Legs and Control Box are secure. If the problem persists,

perform the reset procedure below.

Reset Procedure

1. Unplug the Power Cord and hold the DOWN button on the Keypad for 30 seconds.

2. Plug the Power Cord back in.

3. Hold the DOWN button until the desk reaches its lowest height, then release. Hold

the DOWN button again until the LED display reads "RST" (or for about 10 seconds

on the Basic Keypad without display), then release. Hold the DOWN button again

until the desk lowers a bit, then slightly rises and stops, then release. Your desk is

now ready to use.

4. Advanced Keypads and the Basic Display Keypad will display the current desk height and you should be able to

operate the desk.

5. You may also need to perform this Reset Procedure if the desk is unplugged or loses power.

Code

Description

H01

Overheated

Firmware or

E01-E06

connectivity issues

E07-E012

Legs are uneven

If the error message persists after performing the Reset Procedure above or if there is a height difference between the Legs

which exceeds 1.5'', contact UPLIFT Desk at the email address or phone number listed on these instructions.

Starting & Stopping

If your desk is continuously starting and stopping as you try to raise or lower it, check to make sure the Control Box

is attached securely to the Frame. The Control Box MUST be attached to your Frame in order for your desk to function

properly.