Intermatic InTouch CA5500R User Manual page 73

Step-by-Step with the In-Wall Master Controller
5. When you are satisfied with the new name of
the event, press the
Configure.
6. Press
<ENTER>
configure the event. The
screen displays a list of
all scenes currently in the
network.
7. Scroll with the
first scene to be controlled by this event, then press
to place a "+" sign marking the scene.
<ENTER>
8. Repeat Step 7 for other scenes you want to be
controlled by this event.
9. When finished, press the
arrow button to
<RIGHT>
advance to the bottom of
the screen to select Next,
then press
<ENTER>
currently in the network, along with their current
settings (i.e., ON, OFF, 50%, or --- [it may be added
to the scene at this point]).
OPTION: You can make adjustments at this time
to the setting on any of the devices. Scroll with
the
<UP/DOWN>
you want to change, then press the
arrows to adjust the value. You will have one of three
possibilities:
• For a switch—ON and OFF.
• For a dimmer switch—OFF and a percentage of
ON.
• For a switch not in the scene— three dashes (it
may be added to the scene at this point).
Since you're creating an event that will turn lights
ON, you're probably going to set everything to ON.
Providing a brighter solution.™
button to highlight
<ENTER>
again to
>Configure Event >Configure Event
Event 1 Event 1
arrow buttons to select the
<UP/DOWN>
>Configure Event >Configure Event
Event 1 Event 1
. The display will show all devices
arrow buttons to select the device
+Scene 1 +Scene 1
Scene 2 Scene 2
Scene 3 Scene 3
Bathroom1 Bathroom1
Bathroom 1 Bathroom 1
Binary Switch 5 Binary Switch 5
Multi Level Switch 3 Multi Level Switch 3
<RIGHT/LEFT>

11:25a 11:25a
OFF OFF
75% 75%
11:25a 11:25a