Copying A Scene To Another Intouch Controller - Intermatic InTouch CA5500R User Manual


InTouch™ User Guide

Copying a Scene to Another InTouch Controller

3. Now activate the scene by pressing the
button to turn the scene ON or OFF.
4. Press the
<SCENE SELECTION>
it or the
<HOME>
You can activate the scene from anywhere in your
house, and from at least 50 feet from any device in the
network.
Also, when a scene is ON, the light around its button
is on — so if you have a scene that controls the lights
in the kids' room, you'll know whether lights were left
on just by looking at the button that controls the scene.
This is great for saving trips upstairs to check, out to the
garage, etc.
What if you have more than one InTouch controller
and want each controller to be able to control a scene
you've already created?
You can copy the scene from one InTouch controller to
another.
1. If using a Hand-Held, make sure the lights under the
Hand-Held's buttons are lit. If they are not lit, press
any button to wake the Hand-Held from battery-
saving sleep mode.
2. Press and hold (for approximately 10 seconds) the
<SCENE SELECTION>
to "learn" the scene you have already programmed
on another controller. The Status Light on the
"learning" controller will pulse once with a blue
light.
3. On the other InTouch controller, press the
button that activates the scene you want
SELECTION>
to attach or copy. You can press more than one
<SCENE SELECTION>
to combine several scenes.
NOTE: The scene(s) will activate when you perform
this step. Ignore the activation and continue.
Copyright © 2006 Intermatic, Inc.
button again to deselect
button to deselect a group of scenes.
button on the controller you want
button on more than one device
<ENTER>
<SCENE