Attaching An Existing Scene To A Device - Intermatic InTouch CA5500R User Manual

0
InTouch™ User Guide

Attaching an Existing Scene to a Device

3. When finished, return to the device you are program-
ming and press once and hold (for approximately 10
seconds):
• Motion Sensor—The
• Switch-Type Devices—The lower portion of the
rocker switch.
The Status Light will stay on while the device is
gathering information, and will then:
• Blink BLUE once if programming is successful.
• Blink RED once if programming failed. If this
happens, try again. Refer to the Troubleshooting
Section of this Manual for additional information.
4. Test the programming. Press the
once to activate the scene (or walk in front of the
motion detector), then again to deactivate.
You can attach (or copy) an existing scene—one already
programmed to a button on your Hand-Held or other
InTouch controller—to a switch-type device, or motion
sensor, using the device as an alternate way of activating
the scene.
NOTE: You must have an InTouch Base (Model
CA5500B) for this procedure to work.
1. Depending on which device you want to program,
perform the following step:
• Motion Sensor—Press and hold (for
approximately 10 seconds) the
button.
• Switch-Type Device—Make sure the device
is in OFF mode, then press and hold (for
approximately 10 seconds) the lower portion of
the rocker switch.
The Status Light will pulse once with a blue light,
indicating that the device is in "learning" mode.
Copyright © 2006 Intermatic, Inc.
button.
<ACTIVATION>
<ACTIVATION>
<ACTIVATION>
button