Removing A Scene From A Device - Intermatic InTouch CA5500R User Manual

Removing a Scene from a Device

Programming Scenes with Routing Slave Devices
2. On the controller, press the
that activates the scene you want to attach or copy.
You can press more than one
button on more than one device to combine several
scenes.
NOTE: The scene(s) will activate when you perform
this step. Ignore the activation and continue.
NOTE: If you want, you can make changes to the
scene as it will be controlled by the new device. If
you want to do so, make them now. Any changes
you make will NOT affect the original controller.
3. When finished, return to the device you are program-
ming and press once and hold (for approximately 10
seconds):
• Motion Sensor—The
• Switch-Type Devices—The lower portion of the
rocker switch.
The Status Light will stay on while the device is
gathering information, and will then:
• Blink BLUE once if programming is successful.
• Blink RED once if programming failed. If this
happens, try again. Refer to the Troubleshooting
Section of this Manual for additional information.
4. Test the programming. Press the
once to activate the scene, then again to deactivate.
1. Depending on which device you want to remove a
scene from, perform the following step:
• Motion Sensor—Press and hold (for
approximately 10 seconds) the
button.
• Switch-Type Devices—Make sure the device
is in OFF mode, then press and hold (for
approximately 10 seconds) the lower portion of
the rocker switch.
Providing a brighter solution.™
<SCENE SELECTION>
<SCENE SELECTION>
button.
<ACTIVATION>
<ACTIVATION>
<ACTIVATION>
1
button
button