Linking An Additional Base And Hand-Held To The Network - Intermatic InTouch CA5500R User Manual

Linking an Additional Base and Hand-Held
to the Network
If you have an additional Base and Hand-Held, use the
following procedure to link them to the network.
NOTE: The original Base and Hand-Held must already
be included in the network before you can proceed.
1. Place the new Hand-Held in the new Base. (Make
sure it's powered ON.)
2. Take the original Hand-Held out of its base and press
and release the
Light lights up blue, indicating that it is in Include
mode.
3. Press and hold (for 4+ seconds) the
on the new Hand-Held. When the linking process is
complete, the Status Light on the original Hand-Held
will:
• Blink BLUE once if programming is successful.
• Blink RED once if programming failed. If this
happens, try again. If it fails a second time, refer
to the Troubleshooting Section of this Manual for
additional information.
1. While the new Hand-Held is still in its new Base,
press the
<INCLUDE>
lights up blue, indicating that it is in Include mode.
2. Wait for the Status Light on the new Hand-Held to:
• Blink BLUE once if programming is successful.
• Blink RED once if programming failed. If this
happens, try again. If it fails a second time, refer
to the Troubleshooting Section of this Manual for
additional information.
Providing a brighter solution.™
Setting Up Your Network
button so that its Status
<INCLUDE>
button so that its Status Light
button
<HOME>
1