Intermatic InTouch CA5500R User Manual page 12

1
InTouch™ User Guide
The STATUS LIGHT The STATUS LIGHT
<EXCLUDE> <EXCLUDE>
button button
(on left side) (on left side)
The The
<ENTER> <ENTER>
button button
Press to Press to
<RAISE> <RAISE>
levels levels
The The
POWER LIGHT POWER LIGHT
1. Place the Hand-Held in the Base and make sure the
Base is powered ON.
2. Press and release the
Held so that its Status Light lights up blue, indicating
that it is in Include mode.
3. Wait for the Status Light on the Hand-Held to go out.
When it does, the link is successful. The Status Light
on the Hand-Held will:
• Blink BLUE once if programming is successful.
• Blink RED once if programming failed. If this
happens, reset Base and Remote and try again.
See page 9. If it fails a second time, refer to
the Troubleshooting Section of this Manual for
additional information.
NOTE: If you ever lose or damage your Hand-Held, you
can order a replacement and easily transfer over any
program existing on the old controller. Just follow the
procedure above: place the new Hand-Held in the Base
and press the
<INCLUDE>
Copyright © 2006 Intermatic, Inc.
<INCLUDE> <INCLUDE>
button button
(on right side) (on right side)
<SCENE SELECTION> <SCENE SELECTION>
Press to Press to
<LOWER> <LOWER>
levels levels
The <HOME> button The <HOME> button
has special uses has special uses
button on the Hand-
<INCLUDE>
button.
buttons buttons
explained in explained in
this guide this guide