Locating A Lost Hand-Held; Before You Begin - Intermatic InTouch CA5500R User Manual


InTouch™ User Guide

Before You Begin...

Locating a Lost Hand-Held

If the Hand-Held is misplaced (separated from its Base),
here's how to locate it:
1. Disconnect the Base from the power supply (pull its
plug), then plug it back in. Within about 15 minutes,
when the Base "finds" the Hand-Held, the Hand-
Held will beep and flash.
2. Press any button on the Hand-Held to stop the
beeping and flashing.
NOTE: If for any reason power is interrupted to the
base, the Hand-Held may begin flashing and beeping
even though it is not lost.
Your InTouch system should be set up "from scratch"
when installation is complete. If any prior programming
exists in any controller(s) or other devices — if any of
the devices were ever used before — your system may
not operate as efficiently or predictably as it should.
This might have happened, for example, if the installer
ran some preliminary programming tests on a few
devices of his own, which are not part of your system.
NOTE: This is extremely important! If you are ever
unsure about a device, reset it completely. Using
devices that have not been reset can corrupt the
network information in all your controllers, causing
you to have to completely reset and re-setup every
device in your network.
NOTE: When InTouch devices are initially powered
up, their status indicators will blink blue and/or
red to indicate they are ready to be included into a
network.
Run the following reset procedure to completely
wipe your system clean. Then, when you are sure
about the state of your system, you can proceed with
programming it with the devices that make up your
network.
Copyright © 2006 Intermatic, Inc.