Advertisement
N-Series
3D Printer
B
Hardware Installation (continued)
12
13
14
/ Quick Start Guide
Press the "Utilities" menu on the screen and
set the temperature of the left nozzle for
the filament, then press the "Load" button.
Finish the feeding operation step by step
according to the instructions on the screen.
NOTE:
This document is set based on the Raise3D
PLA filament, which is delivered together with the
printer. Therefore we advise that you use this PLA
for testing.
Feed the filament through the guide tube.
Push the filament down to the feed gear
until the gear grips the filament.
NOTE:
For your first set of prints please use the
left nozzle only. The printer has been pre-cali-
brated based on printing with the left nozzle in
the factory. If you want to print with the right
nozzle or dual extrufers, please follow the
instructions on aligning both extruders found
here: https://www.raise3d.com/pages/faq.
Advertisement
