Table of Contents
Advertisement
Chapter 3 - User's Reference
Setting the Crop Marks, Base Point, and Align Point
– Remove the Printed Material, then Reload the Material and Perform Cutting –
This feature is for performing position alignment in cases where printing is performed, after which the material removed from the
machine for further processing (such as laminating), then again loaded on the machine for cutting.
* Setting crop marks to [ENABLE] changes the printing/cutting area. For more information, see "3-5 About the Printing/Cutting Area."
* When reloading a portion that has already been printed and cut off of the roll, them make sure there is at least 90 mm (3-9/16 in.)
from where printing ended to the rear edge of the material (where it was cut from the roll).
When the material is to be cut off automatically, then at the PC-600 driver [Driver Options] tab, set [Page Spacing] to 90 mm (3-9/16
in.) or more.
1
Hold down the [ALIGN POINT] key on the panel
while you turn the [POWER] key (sub power) on.
The ALIGN POINT LED and the POWER LED
lights up.
3
Use the
and
keys to make the LED for
CARTRIDGE HOLDER 5 light up.
4
The setting is completed when the [POWER] key is
used to switch off the sub power. Crop marks are
now set to [ENABLE].
5
Press the [POWER] key (sub power) to switch on
the power.
You can also enable or disable crop marks by
making the setting using the driver. When you are
making the setting with the driver, steps 1 through 5
are not necessary.
7
When printing finishes, raise the sheet loading
levers, remove the material, and perform lamination
(or whatever further processing needs to be done).
When done, reload the material in about the same
position used for printing and lower the sheet
loading levers. (The SETUP LED lights up.)
10
Set the base point
1)
Use the arrow keys to move
the tip of the alignment tool
to the square crop mark at
the lower right area of the
material, then press the
[BASE POINT] key.
• The align point cannot be set to both the lower left and upper right points.
• The align point cannot be set if the angle between the base point and the align point is 5 degrees or more.
• Marks set with the application software (such as crop marks) cannot be used.
46
2
Use the
and
CARTRIDGE HOLDER 1 and 3 light up.
6
Send the printing data from the computer.
Three crop marks are automatically printed on the
left and right areas at the front edge of the material.
8
Use the
and
center of the platen.
9
Install the alignment tool on the cutting carriage.
Rear
Set the align point
2)
Use the arrow keys to move
the tip of the alignment tool
to the crop-mark corner in
Front
the length direction of the
material (at either the lower
left or upper right).
Then press the [ALIGN
POINT] key.
keys to make the LEDs for
Rear
Front
Crop marks
keys to move the carriage to the
Hide quick links:
Advertisement
Table of Contents
