Self-Test - Roland ColorCAMM PRO PC-600 User Manual

Chapter 2 - Basic Operation

2-6 Self-test

Do not allow hands or hair to come
near the platen while the carriage is
in motion.
Failure to do so may result in injury due to
sudden movement of the carriage when the
power is switched on/off, when the sheet
loading lever is raised or lowered,
or when the [CUT TEST] key, [SHEET CUT]
key, [DATA CLEAR] key, or [HEAD
CLEANING] key is pressed.
The PC-600 is equipped with a "self-test" function to allow you to check whether or not it is capable of operating normally. If the PC-600
is not performing correctly, follow the steps below to perform a self-test.
A computer is not required in order to carry out the self-test.
1
Leave on the main power for the PC-600, and
switch off the sub power.
3
Hold down the key on the panel while you turn
the [POWER] key (sub power) on.
5
Gently close the front cover.
Self-test starts.
After the operation check has finished, raising the sheet loading lever cancels the operation check mode. After that, the unit just as it
does when the power has been switched on in the normal manner.
34
+
2
Install blade holders and four-color (CMYK) ribbon
cartridges on the PC-600.
4
Load material and lower the sheet loading lever.
6
Operations is normal if the figure shown at below.
Full-color
printing
Settings on the machine
Cutting