Set-Up And Connections - Roland ColorCAMM PRO PC-600 User Manual

1-2 Set-up and Connections

Ground the unit with the ground
wire.
Failure to do so may result in risk of
electrical shock in the even of a mechanical
problem.
Unpacking, installing, or relocating
the unit are operations which must
be carried out by two or more per-
sons holding the unit at its bottom
surface on the left and right sides.
Failure to do so may
result in dropping
the unit, leading
to injury.
NOTICE
Do not hold the upper portion of the PC-600 when installing or moving the unit.
Avoid installing the PC-600 in the following conditions, as this may result in damage to the machine.
• Avoid use in locations subject to high levels of electrical noise (near motors, generators, transformers, and
the like).
• Avoid use in locations subject to high humidity or dust.
• The unit becomes hot during use. Do not install in locations where heat radiation is inadequate (i.e., areas
with poor ventilation).
• Do not install in locations subject to strong vibration.
• Do not install in a location exposed to direct sunlight or other strong light.
• Install in an environment having a suitable operating temperature and humidity.
Always make sure that the main power switch is switched off on both the computer and the PC-600 whenever
any cables are connected or disconnected.
Do not put the hands inside the left and right covers. Doing so may result in breakdown of the unit.
Do not touch the reflective panel with the hands.
If the reflective panel is soiled, it may become impossible to replace the ink-ribbon cartridge correctly.
Do not use with any electrical power
supply that does not meet the
ratings displayed on the unit.
Use with any other power supply may lead
to fire or electrocution.
Install in a level and stable location.
Otherwise the unit may tip over and cause
injury.
Chapter 1 - Introduction
11