Chapter 2 - Basic Operation; Installing A Blade - Roland ColorCAMM PRO PC-600 User Manual

Chapter 2 - Basic Operation

2-1 Installing a Blade

NOTICE
When installing or removing a blade, make sure the sub power for the PC-600 is switched off and no material is
loaded.
When mounting the blade holder, do not depress the plate slide.
Do not touch the tip of the blade. This could impair the cutting performance of the blade.
To mount the tool holder, insert the tool holder until its collar lies flush against the upper portion of the
mounting hole.
1
Insert blade into the blade holder until it snaps into
place with an audible click.
Blade holder
Blade
2) Insert the blade.
Adjusting the Cutter Blade
As shown in the figure, turn the tip of the blade holder to determine
the optimal blade amount for the target material.
- Adjust the tip of the blade to a length shorter than the thickness of
the sheet (material) to be cut.
- Gradually extend the blade tip while doing test cutting to
determine the optimum blade tip length for the sheet to be cut.
- When cutting becomes impossible under identical conditions,
increase tool force or extend the blade and carry out cutting again.
Pin
1) Insert the pin.
(Leave the pin
inserted.)
Plate slide
2
2) Support the tool-securing screw from below and
install the blade holder.
* Insert the blade holder until the collar is flush
with the carriage.
1) Loosen
* One full rotation moves the blade
0.5 mm (0.0197 in.) up or down.
(Scale shows gradations of 0.1
mm (0.00394 in.))
Chapter 2 - Basic Operation
Cutting carriage
3) Tighten
21