Roland ColorCAMM PRO PC-600 Frequently Asked Questions

Hide thumbs Also See for ColorCAMM PRO PC-600:

My output is grainy and has dot-like specs and streaks. How can I fix this?

How do I print with Spot Colors?

My output is printing with lines through the center of my image; it looks like a

horizontal space or a gap across the image. How can I fix this?

Why does my ColorCAMM PRO PC-60 0 material begin to skew (travel or shift)

from left to right after it has cut 1 or 2 feet?

Why are my circles or certain letters not meeting (coming together to form a

complete circle) at the end of the cut line?

Why is the blade cutting deep in some areas and not in others? My

ColorCAMM PRO PC-60 is cutting jagged and jumps.

What should I do when the Piece LED and Roll LED blink simultaneously?

10.

11.

Can my PC-600 pull vinyl directly off a Roll?

12.

1. My output is grainy and has dot-like specs and streaks. How can I fix this?

Make sure to use clean vinyl and keep the platen, which is a very thin metal

strip below the print head towards the right side, clean. Use a soft dry cloth to

clean the vinyl or you may use a denatured alcohol cleaning solution like

ColorCAMM PRO PC-600

Frequently Asked Questions

Table of Contents

Do you have a question about the ColorCAMM PRO PC-600 and is the answer not in the manual?

Page 1 ColorCAMM PRO PC-600 Frequently Asked Questions My output is grainy and has dot-like specs and streaks. How can I fix this? How do I print with Spot Colors? My output is printing with lines through the center of my image; it looks like a horizontal space or a gap across the image.
Page 2 Isopropyl. Do not use the cleaning sheet to clean the print head more than twice in one cleaning. The cleaning pen should be used to clean underneath the head. The platen should be wiped with the cleaning pen. If the ribbon cartridge went over the platen and laid down color, this could cause streaks to print.
Page 3 slow down the cut speed and, depending on the type of material, the offset may need to be set at 0.5mm. You should also check the communication settings to make sure your software is configured with the recommended settings for the type of connection that you are using: serial or parallel. 6.
Page 4 10. What should I do when the Piece LED and Roll LED blink simultaneously? Make sure the pinch rollers are in the proper position and make sure the eye sensors are covered by material. 11. What should I do when the Roll LED is flashing? Lower the sheet loading lever to secure the material in place.