Table of Contents
Advertisement
6
Lower the sheet loading levers to secure the material in place.
7
* Only when using rolled material
Attach the stoppers to the edges of the roll material
and tighten the screws to secure in place.
When the sheet loading lever is lowered, the
carriage begins to move.
Setup is
The width of the material is detected, and the
finished.
carriage stops at the material's right-hand edge.
When no setting is made for BASE POINT,
the point where the unit stops here becomes
the base point.
Chapter 2 - Basic Operation
Roll material
Stopper retaining screw
27
Hide quick links:
Advertisement
Table of Contents
