Roland ColorCAMM PRO PC-600 User Manual page 28

Chapter 2 - Basic Operation
Side view of loaded roll material
When using a thick roll of
material
Shafts
4
Position so that the left-hand edge of the material lies over any one of the grit rollers.
Move the material from side to side and position so that the right-hand edge of the material lies over the rightmost grit roller.
Cleaning pad
Make sure any objects are not over the cleaning pad.
Damage to the head may result.
5
Load the material so that it lies straight and is aligned with the guideline stickers, then move the left and right pinch rollers so
that at they are above the grit rollers. (If the grit rollers are hidden by the material, align the pinch rollers with the grit roller
position indicators.)
Material
alignment
stickers
26
When only a small amount
of material remains
(material diameter is 72
mm (2-7/8 in.) or less)...
Shafts
The holes on the rail portion are guides for positioning the grit rollers.
Not OK
Shafts
Rear sensor
Grit roller (right)
Front sensor
Make sure the material lies
over the front and rear sensors.
Material
alignment
stickers