Roland ColorCAMM PRO PC-600 User Manual page 46

Chapter 3 - User's Reference
Making the Settings
1) Hold down the [ALIGN POINT] key on the panel while you turn the [POWER] key (sub power) on. The ALIGN POINT LED and
the POWER LED lights up.
2) Pressing the and
3) Referring to the table below, use the
want to set.
4) The setting is completed when the [POWER] key is used to switch off the sub power.
The setting that has been made is stored in memory even after the power is switched off. To change the setting, simply repeat the
procedure just described.
You can perform an operation check to check the present settings with the printing results. For more information about the operation
check, see "2-6 Self-test."
Functions
Auto sheet cut
Auto-sleep
Front edge sense
Blade offset
Crop marks
Prefeed mode
Beep
(warning sound for the ink-ribbon cartridges)
Ribbon Saver
44
keys changes the displayed CARTRIDGE HOLDER LEDs.
and keys to illuminate or extinguish the CARTRIDGE HOLDER LEDs for the value you
CARTRIDGE HOLDER LED
Setting item
: Lights up : Dark
CARTRIDGE HOLDER LED
Value
Setting state
Enable
Disable
30 min.
60 min.
Disable
Disable
Enable
0.25 mm
0.50 mm
Disable
Enable
Enable
Disable
Enable
Disable
Enable
Disable
Factory
Default
√
√
√
√
√
√
√
√