Roland ColorCAMM PRO PC-600 User Manual page 27

* Only when using rolled material
1
Pass the stopper onto the shaft to match the width of
the roll material to be used. (The shafts (2 pieces),
stoppers (2 pieces), and stopper retaining screws (2
pieces) are included with the stand.)
When fitting the stoppers onto the shaft, loosen the
stopper retaining screws and pass the stoppers onto
the end of the shaft where the hole is present.
2
Set the two shafts in place and attach the brake.
3
Install the two shafts on the sheet hanger and place
the roll material on top of the shafts.
When you are using roll material, make the setting
on the PC-600 to set the prefeed function to
[ENABLE] (the factory default is [ENABLE]).
Before performing printing or cutting, the length of
material required for output is automatically pulled
out from the roll, then returned to the rear, where it
is left slack. If output is performed without carrying
out this operation first, printing or cutting may be
misaligned, or the material may come loose or jam.
If the setting for disabling the prefeed function has
been made on the machine, then pull out from the
roll the length of material required.
(If the prefeed function is enabled, there is no need
to pull out material.)
Rear view
Shaft
Stopper retaining screws
Stopper
Brake Screw
Sheet hanger
Sheet hanger
Stoppers
Chapter 2 - Basic Operation
Shaft
Move the brake toward the shaft
OK
Not OK
Sheet hanger
Shafts
Front
Rear
Stopper
25