Starter Clutch - Suzuki Vinson LT-A500F Service Manual

S T A R T E R C L U T C H
• Hold the rotor with a 36-mm offset wrench and remove the
hexagon bolts.
• Install the starter clutch in the proper direction as shown.
NOTE:
When installing the starter clutch onto the rotor, make sure the
notch ® in the bearing faces to the rotor.
• Apply engine oil to the starter clutch.
• Apply THREAD LOCK SUPER "1303" to the hexagon bolts,
and then tighten them to the specified torque while holding
the rotor and using a 36-mm offset wrench.
t t i 3 99000-32030: THREAD LOCK SUPER "1303"
H Starter clutch bolt: 26 N m (2.6 kgf-m, 19.0 Ib-ft)
• Install the starter gear © to the starter clutch.
• Check that the rotor © turns in the direction of the arrow ®
on the rotor while holding the starter gear, and that the rotor
never turns in the opposite direction of the arrow.