Suzuki Vinson LT-A500F Service Manual page 284

Make sure the air bubbles © rise to the top of each electro-
lyte container and leave the electrolyte container in this posi-
tion for more than 20 minutes.
NOTE:
If air bubbles do not rise from any one of the filler ports, tap the
bottom of the electrolyte container two or three times.
Never remove the electrolyte container from the battery while
there is still electrolyte in the container.
• After the electrolyte container is completely empty, remove it
from the battery and wait about 20 minutes.
• Insert the caps © firmly into the filler holes, so that the top of
the caps do not protrude above the upper surface of the top
cover of the battery.
A C A U T I O N
The charging system for an MF battery is different
from that of a conventional battery. Only use the
specified MF battery.
Do not remove the caps once they are installed in
the battery.
Measure the battery voltage using the multi circuit tester. If the
battery voltage is lower than the specified value, charge the
battery with a battery charger.
IT55LI 09900-25008: Multi circuit tester set
Battery voltage
Standard: 12.5-12.6 V (DC)
NOTE:
Initial charging for a new battery is recommended if two years
have elapsed since the date of manufacture.
ELECTRICAL SYSTEM
(at 25°C)
(V)
13
t—
12
11
10
2 4 6
8
Time
8-29
10 (Minutes)