Suzuki Vinson LT-A500F Service Manual page 255

7-66 CHASSIS
• Install the range lever cable © into the cable stopper ®
located on the frame. Then, finger tighten the range lever
cable adjusting nuts @ to hold it in place.
NOTE:
Make sure the range lever cable is positioned so that the cable
stopper ® on the frame is between the range lever cable
adjusting nuts ® and washers @.
• Turn the cable adjusting nuts to align the range lever cable
eye rod hole © with the projection © on the range shift lever
arm.
• Tighten the adjusting nuts to securely.
A CAUTION
Make sure to adjust the gearshift cable length prop-
erly. Improper adjustment may result in poor shifting
and damage to the cable, selection lever, or range
lever.
• Fasten the range lever cable and range lever arm, by install-
ing the range shift lever cable, washer and E-ring.
NOTE:
Direction of the eye rod is determined by the side (differential
case or crankcase side) it is installed on.
A CAUTION
Be sure to install the range lever eye rod accurately
and that the end face of the selection lever contacts
the flange face of the bushing © of the selection lever
cable.
NOTE:
In handling the push-pull cable, use care not to bend it. Shown
in the illustration is a strictly prohibited example.
A CAUTION
Do not apply a load to the end of the eye rod with the
cable and the metal fixture. Applying such a load may
cause the sleeve to break or come off the pivot sus-
pension.
Sleeve Boot
Metal fixture
Eye rod
Nut
LOAD