Engine Coolant Temperature Switch Removal; Engine Coolant Temperature Switch Inspection; Engine Coolant Temperature Switch Installation - Suzuki Vinson LT-A500F Service Manual

ENGINE COOLANT TEMPERATURE
SWITCH
REMOVAL
• Remove the left front fender side cover. ( d T
• Disconnect the engine coolant temperature switch coupler
and remove the engine coolant temperature switch.
INSPECTION
Check the operating temperature of the engine coolant temper-
ature switch.
• Connect the multi circuit tester to the engine coolant temper-
ature switch.
• Place the engine coolant temperature switch into a container
of oil.
• Heat the oil and check the temperature on the thermometer
when the engine coolant temperature switch is operated.
IT55LI 09900-25008: Multi circuit tester set
PHBS Engine coolant temperature switch specification
OFF -> ON
ON - » O F F
INSTALLATION
Install the engine coolant temperature switch in the reverse
order of removal. Pay attention to the following points:
• Apply SUZUKI BOND "1207B" to the thread portion of the
engine coolant temperature switch and tighten it to the spec-
ified torque.
For USA
4 E | 99104-31140: SUZUKI BOND "1207B"
For the other countries
4^1 99000-31140: SUZUKI BOND "1207B"
H Engine coolant temperature switch:
A CAUTION
Take special care when handling the engine coolant
temperature switch. Do not subject it to strong blows
or allow it to be dropped.
• After installing the engine coolant temperature switch, be
sure to add engine coolant, ( d r * 2-11)
7-5)
3
Approximately 115°C (239T)
Approximately 108°C (226°F)
7.5 N m (0.75 kgf-m, 5.5 Ib-ft)