Appendix 2 - Keys Reference - Simrad RS90S User Manual

6.
7.
Key
Reference
VOL
The volume control is on the side of RS90S handset.
This key also adjusts the volume of an external speaker, if connected.
16 / 9
Press [16/9] to immediately switch to the priority channel.
Press again to return to your original channel. The default Priority Channel
is CH16.
In the USA, you can toggle between Channel 16 and Channel 9 as the
priority channel. Hold down [16/9] until a beep sounds and the required
priority channel is displayed.
DISTRESS
The red [DISTRESS] key on top of the handset sends a DSC distress call.
DSC must be switched on and an MMSI must have been entered into the
radio.
For more information, see "Introduction to DSC" on page 40.
PTT
The Push to Talk (PTT) key enables the microphone and transmits your
voice over the selected channel, see "PTT Key" on page 23.
OK
This key has multiple functions depending on the operation you are doing:
Sets the high/low transmission power.
The Hi or Lo icon on the display changes.
In menus, press to confirm the selection.
▲ and ▼
Used for changing channel and for scrolling through menu options.
◄ and ►
Used for adjusting squelch and moving the cursor when entering data on a
wired handset.
Battery symbol is displayed.
The power supply is too low.
Check the battery voltage. This should be at least 10.5 V ± 0.5 V DC.
Check the alternator on the vessel.
GPS alarm sounds and LCD shows: Please check GPS link! The NO
GPS symbol is shown.
GPS data has been lost. This sequence will repeat every 4 hours
until GPS data from an operational GPS receiver is available. The GPS
cable may faulty or the GPS setting may be incorrect:
Check that the GPS cable is physically connected.
Check the polarity of the GPS cable.
Check the baud rate setting of the GPS if applicable. The baud rate
setting should be 4800. Parity should be set to NONE.
Appendix 2
Appendices |
- Keys reference
RS90S User Manual
| 111