Using The Fog Horn - Simrad RS90S User Manual

16
Hi
DSC
C
HAILER
PRI
HAILER
FOG HORN
INTERCOM
ANNOUNCE
USA
16
Lo
Hi
DSC
FOG HORN
HORN PRI
UNDERWAY
STOP
SAIL
USA
16
Hi
DSC
DSC
HORN
PRI
OUTPUT
VOL
LO HI
USA
16
Hi
DSC
HORN PRI
LISTEN
¼ Notes:
USA

Using the fog horn

If the RS90S is connected to a suitable public address (PA) speaker,
you can use the Fog Horn function to sound certain international
standard fog horn tones through the PA speaker.
1.
Press and hold [AIS/IC] until the HAILER menu appears.
2.
Select FOG HORN.
There are 8 internationally recognized fog horn signals available:
HORN
UNDERWAY
STOP
SAIL
ANCHOR
TOW
AGROUND
SIREN
3.
Select the required signal, then press [OK] to start.
•
Press [OK] to sound the HORN or SIREN.
•
The other signals will sound automatically approximately every
two minutes until you press [X] to cancel.
4.
When finished, press [X] to exit horn mode.
•
When the fog horn is not sounding, it is in Listen mode.
•
While pressing [PTT], you can change the volume of the PA system
using the volume control on the side of the handset.
•
In Horn mode, you can press [PTT] to talk through the PA speaker.
•
If a horn button has been installed, you can press the button for a
momentary sounding of the horn.
Operating procedures |
Manual operation
One long tone
Two long tone
One long, two short
One long warble
One long, three short
Warble sequence
Manual operation
RS90S User Manual
| 33