Simrad RS90S User Manual page 97

16
Hi
DSC
C
MENU SELECT
PRI
CONTRAST
GPS/DATA
RADIO SETUP
DSC SETUP
USA
16
Hi
DSC
C
DSC SETUP
PRI
USER MMSI
GROUP SETUP
ATIS MMSI
ATIS SELEC
INT
16
Hi
DSC
C
PRI
INPUT ATIS
MMSI
9 - - - - - - - - -
INT
16
Hi
DSC
C
MENU SELECT
PRI
CONTRAST
GPS/DATA
RADIO SETUP
DSC SETUP
USA
16
Hi
DSC
C
DSC SETUP
PRI
USER MMSI
GROUP SETUP
ATIS MMSI
ATIS SELEC
INT
16
Hi
DSC
C
ATIS SELECT
PRI
ON
OFF
DSC IS ON
INT
Entering or checking your ATIS MMSI
EU models only.
The ATIS MMSI is a special MMSI that is used on inland waterways
in Europe for identifying the ship or vessel that made a VHF radio
transmission. The MMSI is transmitted on the VHF channel each
time the radio operator finishes talking and releases the PTT key. For
further information, see "ATIS" on page 62.
¼ Notes:
•
You can display and read your ATIS MMSI at any time, but you can
only enter it once.
•
Enter the number carefully before pressing [OK] the second time. If
you make a mistake, the radio will have to be sent back to the dealer
to be reset.
Select MENU → DSC SETUP → ATIS MMSI.
1.
If you have already entered your ATIS MMSI, it is shown on screen.
If you are entering a new ATIS MMSI, a dashed line appears.
2.
Enter your ATIS MMSI along the dashed line, one number at a time.
An ATIS MMSI always starts with the number 9.
3.
Press [OK].
4.
Enter your ATIS MMSI again as a password check, then press [OK] to
permanently store the ATIS MMSI.
Enabling ATIS functionality
EU models only.
Select MENU → DSC SETUP → ATIS SELECT.
1.
2.
Scroll to ON or OFF as required and press [OK].
¼ Notes:
•
Before you can enable ATIS, you must enter an ATIS MMSI. See
"Entering or checking your ATIS MMSI" above.
•
Before you can enable ATIS, DSC must be turned off. See "Enabling
DSC functionality" on page 98.
•
When ATIS is enabled, the ATIS icon is displayed on screen.
•
In some European countries, SCAN functionality is limited, and, if
ATIS is enabled, the 3CH SCAN mode will be disabled.
Setup | RS90S User Manual
| 97