Navigating To A Waypoint - Simrad RS90S User Manual

16
Hi
DSC
C
WAYPOINT
PRI
WP LIST
NEAREST WP
USA
16
Hi
DSC
C
WP LIST
PRI
NEW WP
HARBR
FISH1
FISH2
USA
16
Hi
DSC
C
FISH2
PRI
WP EDIT
DELETE
GO
TX WPT DATA
USA
16
Hi
DSC
C
WAYPOINT
PRI
WP LIST
NEAREST WP
USA
16
Hi
DSC
C
NEAREST WP
PRI
FISH1 243
t
n
2
m
FISH2 075
t
n
8
m
USA
38 |

Navigating to a waypoint

Navigating to a waypoint requires two steps:
•
Selecting which waypoint you want to navigate to.
•
Pressing [NAV] to go to Navigation mode.
These steps are explained below.
Selecting a waypoint from your list
1. Select MENU → WAYPOINT → WP LIST.
2.
Press [OK] and then scroll to the required waypoint and press [OK]
again.
3.
Select GO.
4.
When prompted, select YES.
When in Navigation mode (see below), the distance and bearing
from your current position to the selected waypoint will be
displayed on the bottom line of the standby screen.
Selecting the nearest waypoint
¼ Note:
This option is only available when a valid signal from a GPS
device is present.
1. Select MENU → WAYPOINT → NEAREST WP.
The display shows your list of waypoints with the nearest at the top.
2.
Scroll to the required waypoint and press [OK].
When in Navigation mode, the distance and bearing to it from your
current position will be shown on the bottom line of the standby
screen.
Waypoint procedures | RS90S User Manual