Three Favourite Channels 3Ch; Scanning Channels - Simrad RS90S User Manual

03
Lo
DSC
OVER WRITE
CH3?
A
YES
NO
USA
16
Hi
DSC
3CH MODE
DELETE CH1?
D
YES
CH1
NO
USA

Three favourite channels 3CH

Once set up, you can use the three favourite channels in two ways:
•
Repeat press [3CH] to toggle between your three favourite channels,
or
•
Scan the three channels and the priority channel.
To add a favourite channel:
•
To add a favourite channel for the first time, select that channel then
hold 3CH to store it in the CH1 location.
•
You can repeat the procedure to store two more favourite channels
in the CH2 and CH3 locations respectively.
•
Once the three locations are full, if you try to add another favourite
channel, the radio will overwrite the CH3 location after prompting
you to confirm.
To delete a favourite channel:
•
Select that channel and then hold down [3CH]. The radio will
remove that favourite channel after prompting you to confirm.
To toggle between your three favourite channels:
•
Press [3CH] to enter 3CH mode.
•
The radio displays "3CH MODE" and CH1, CH2, or CH3 to show
which of your favourite channels is currently selected.
•
Repeat press [3CH] to switch between the three channels.
To exit 3CH mode:
•
Press [X].

Scanning channels

The RS90S can automatically monitor more than one channel at the
same time. It scans a selected range of channels, and when a valid
signal is received, the radio stops scanning and remains on that
channel so that you can hear the communication. However, if the
signal from the channel ceases for more than 5 seconds, the scan
automatically restarts.
Four scan modes are provided:
•
All scan
Scans all available channels in sequence, but also checks the priority
channel every 2 seconds.
Operating procedures | RS90S User Manual
| 29